For feedback and comments:
documentation.feedback@alcatel-lucent.com

Table of Contents Previous Next PDF


Show Commands
bof
Syntax
bof [cflash-id | booted]
Context
show
Description
This command displays the Boot Option File (BOF) executed on last system boot or on the specified device.
If no device is specified, the BOF used in the last system boot displays. If the BOF has been modified since the system boot, a message displays.
Parameters
cflash-id
The cflash directory name. The slot name is not case-sensitive. Use upper or lowercase “A” or “B” for the slot name.
Values
booted
Displays the boot option file used to boot the system.
Output
Show BOF Fields
The following table describes BOF output fields.
The IP address and mask associated with the CPM Ethernet port or the secondary CPM port.
The speed of the CPM Ethernet interface.
Sample Output
A:ALA-1# show bof cf3:
=====================================================================
BOF on cf3:
=====================================================================
autonegotiate
	primary-image    ftp://test:test@192.168.xx.xx/./both.tim
	primary-config   ftp://test:test@192.168.xx.xx/./1xx.cfg
	secondary-image  cf1:/i650/
	secondary-config cf1:/config.cfg
	address          192.168.xx.xxx/20 active
	address          192.168.xx.xxx/20 standby
	primary-dns      192.168.xx.xxx
	dns-domain       test.test.com
	autonegotiate
	duplex           full
	speed            100
	wait             2
	persist          off
    	console-speed    115200
===============================================================================
A:ALA-1# 
A:ALA-1# show bof booted
=====================================================================
System booted with BOF
=====================================================================
	primary-image    ftp://test:test@192.168.xx.xx/./both.tim
   	primary-config   ftp://test:test@192.168.xx.xx/./103.cfg
   	secondary-image  cf1:/i650/
   	secondary-config cf1:/config.cfg
   	address          192.168.xx.xxx/20 active
   	address          192.168.xx.xxx/20 standby
   	primary-dns      192.168.xx.xxx
   	dns-domain       test.test.com
   	autonegotiate
   	duplex           full
   	speed            100
   	wait             2
	persist          off
    	console-speed    115200
===============================================================================
A:ALA-1# 
boot-messages
Syntax
boot-messages
Context
show
Description
This command displays boot messages generated during the last system boot.
Output
Show Boot Messages Fields
The following output shows boot message output fields.
Sample Output
ALA-## show boot-messages 
Boot log started on CPU#0
  Build: X-1.2.B1-7 on Thurs Jan 13 14:49:23 201 by builder
  CPUCTL FPGA version: 2A
Forcing BDB controller to HwSlot 0
Performing Power on Diagnostics
>>>Testing mainboard FPGA chain...
JTAG chain length = 2
All requested FPGAs on chain programmed
>>>Validating SDRAM from 0x21f00000 to 0x22000000
>>>Testing SDRAM from 0x02200000 to 0x21f00000
>>>Testing Compact Flash 1... Slot Empty
>>>Testing Compact Flash 2... Slot Empty
>>>Testing Compact Flash 3... OK (TOSHIBA THNCF128MBA)
Wales peripheral FPGA version is 0x13
Hardware Slot 31
Card type in EEPROM is 0x6, 'england_r1'
MDA #1: HwType 0x02, 'denmark_r1', Serial Number 'de3-52'
MDA #2: HwType 0x16, 'hungary_ds3_e3_12_r1', Serial Number 'hun01-02'
Board Serial Number is 'eng02-15'
Chassis type 4 (sr1) found in BP 1 EEProm
Chassis Serial Number is '0203210096'
JTAG chain length = 2
All requested FPGAs on chain programmed
Searching for boot.ldr on local drives:
Searching cf3 for boot.ldr...
********************************************************
    Loaded 0x001bc191 bytes from cf3 to 0x80400000
    Decompressing to address 0x0a000000
Starting code...
 
Total Memory: 512MB  Chassis Type: sr1  Card Type: england_r1
TiMOS-L-1.2.B1-7 boot/hops/T2.02  Copyright (c) 2000-2011 Alcatel, Inc.
Built on Thurs Jan 13 15:15:25 2003 by builder in /rel1.2/b1/B1-7/panos/main
 
TiMOS BOOT LOADER
Time from clock is Thurs Jan 13 08:39:03 2011 UTC
Error:  could not open boot messages file.
Boot messages will not be stored.
 
Looking for cf3:/bof.cfg ... OK, reading
 
Contents of Boot Options File on cf3:
    primary-image    ftp://vxworks:vxw0rks@192.168.15.1/./rel/0.0/I129
    primary-config   cf3:/config.cfg
    address          192.168.13.48/20 active
    primary-dns      192.168.1.254
    dns-domain       eng.timetra.com
    autonegotiate
    duplex           full
    speed            100
    wait             3
    persist          off
 
Hit a key within 1 second to change boot parms...    
 
Primary image location: ftp://vxworks:vxw0rks@192.168.15.1/./rel/0.0/I129
Initializing management port tme0 using IP address 192.168.13.48.
Loading image ftp://vxworks:vxw0rks@192.168.15.1/./rel/0.0/I129/both.tim
Version B-0.0.I129, Thurs Jan 13 21:24:57  2011 by builder in /rel0.0/I129/panos/main
text:(8906865-->21711576) + data:(587508-->5418992)
Executing TiMOS image at 0x2800000
 
Total Memory: 512MB  Chassis Type: sr1  Card Type: england_r1
TiMOS-B-0.0.I129 both/hops/T2.02  Copyright (c) 2000-2011 Alcatel.
All rights reserved. All use subject to applicable license agreements.
Built on Thurs Jan 13 21:24:57 2011 by builder in /rel0.0/I129/panos/main
 
 
 
 
 
 
 
 
 
   ___                    ___           ___           ___
  /\  \                  /\__\         /\  \         /\  \
  \:\  \        ___     /::|  |       /::\  \       /::\  \
   \:\  \      /\__\   /:|:|  |      /:/\:\  \     /:/\ \  \
   /::\  \    _\/__/  /:/|:|__|__   /:/  \:\  \   _\:\~\ \  \
  /:/\:\__\  /\__\   /:/ |::::\__\ /:/__/ \:\__\ /\ \:\ \ \__\
 /:/  \/__/ /:/  /   \/__/~~/:/  / \:\  \ /:/  / \:\ \:\ \/__/
/:/  /     /:/  /          /:/  /   \:\  /:/  /   \:\ \:\__\
\/__/      \/__/          /:/  /     \:\/:/  /     \:\/:/  /
                         /:/  /       \::/  /       \::/  /
                         \/__/         \/__/         \/__/
Time from clock is THU JAN 13 08:39:11 2011 UTC
Attempting to exec configuration file:
'cf3:/config.cfg' ...
System Configuration
Log Configuration                     
Card Configuration
Port Configuration
Router (Network Side) Configuration
Service Configuration
Router (Service Side) Configuration
Executed 232 lines in 0.0 seconds from file cf3:\config.cfg
ALA-1#