For feedback and comments:
documentation.feedback@alcatel-lucent.com

Table of Contents Previous Next PDF

Configuring Logging with CLI
This section provides information to configure logging using the command line interface.
Topics in this section include:
•
Basic Facility Alarm Configuration
•
Common Configuration Tasks
Basic Facility Alarm Configuration
The most facility alarm configuration must have the following:
•
Log ID or accounting policy ID
•
A log source
•
A log destination
The following displays an alarm configuration example.
A:ALA-12>config>system# alarms
#------------------------------------------
        no shutdown
        exit
----------------------------------------------
 
 
Common Configuration Tasks
The following sections are basic alarm tasks that can be performed.
•
Configuring the Maximum Number of Alarms To Clear
 
Configuring the Maximum Number of Alarms To Clear
The number of alarms to clear can be configured using the command listed below.
Use the following CLI syntax to configure a log file:
CLI Syntax: config>system
alarms
max-cleared max-alarms
The following displays facility alarm configuration example:
ALA-12>config>system# alarms
----------------------------------------------
...
	max-cleared 100
	exit
...
----------------------------------------------