Procedure 11-30: Enable/Disable LAN port transmission
Overview
Use this procedure to enable/disable LAN port transmission. Port Administration Control provides the capability to enable/disable the transmission of frames to or from a LAN port. When the port is disabled no new packets are received or transmitted.
Before you begin
Prior to performing this procedure, refer to Before you begin and Required equipment in this chapter and you must have complete work instructions for this procedure that detail the shelf slots, circuit packs, ports that are being enabled/disabled.
Steps
Use the following procedure to enable/disable LAN port transmission.
1 |
Use the WaveStar® CIT to log in to the Alcatel-Lucent 1665 DMX shelf. Reference: Procedure 14-2: Connect Personal Computer (PC) and establish WaveStar® CIT session |
2 |
Select the Configuration → Equipment from the System View menu. Select and expand the details for the circuit pack containing the LAN port. Highlight the LAN Port, then click Select. |
3 |
Important! Disabling a LAN port will disable all frames to and from the port. Click on the "Port Data" tab. For Port Administration Control, select ENABLE to enable the LAN port. Select DISABLE to disable the LAN port. Click Apply, read the warning message, then click Yes to execute the command. Click Close to exit. End of steps |