The following table shows miscellaneous provisionable parameters.
|
Parameter |
TL1 Commands (Access) (Note) |
Range |
Default |
Related WaveStar® CIT Commands |
|---|---|---|---|---|
|
Alarm Clear Delay (clrdel) |
SET-ATTR- ALM (P, G) |
0-30 sec. |
10 |
Configuration → Alarms → Alarm Configuration |
|
Incoming Signal Alarm Delay (almdel) |
0-30 sec. |
2 | ||
|
Miscellaneous Discrete Alarm Notification Code (ntfcncde) |
SET-ATTR- ENV (P, G) |
CR, MJ, MN, NA |
1-14: MN 15: MJ 16-19: MN |
Configuration → Misc. Discretes |
|
Miscellaneous Discrete Alarm Type (almtype) |
1-10 alphanumeric characters |
1-14: MISC 15: not provisionable 16-19: MISC | ||
|
Miscellaneous Discrete Alarm Message (almmsg) |
Up to 26 alphanumeric and symbolic characters (case-sensitive) |
1-14: environment 15: not provisionable 16-19: environment | ||
|
Miscellaneous Discrete Control Type (conttype) |
SET-ATTR- CONT (P, G) |
Up to 26 alphanumeric and symbolic characters (case-sensitive) |
control (1-4) | |
|
Note: The TL1 command security access levels are Privileged (P), Administration (A), General (G), Maintenance (M), and Reports-only (R). | ||||
| November 2011 | Copyright © 2011 Alcatel-Lucent. All rights reserved. |