Cross-Connection parameters

The following table shows the provisionable cross-connection parameters.

Table A-6: Cross-Connection parameters

Parameter

TL1 Commands (Access) (Note)

Range

Default

Related WaveStar® CIT Commands

VT1.5 Cross-Connect Type (cct)

ENT-CRS-VT1

ED-CRS-VT1

ENT-ROLL-VT1

(P, G)

1way

1waypr

None

Configuration → Cross-Connections

Configuration → Ethernet Service

STS-1 Cross-Connect Type (cct)

ENT-CRS-STS1

ED-CRS-STS1

ENT-ROLL-STS1

(P, G)

STS-3c Cross-Connect Type (cct)

ENT-CRS-STS3c

ED-CRS-STS3c

ENT-ROLL-STS3c

(P, G)

STS-12c Cross-Connect Type (cct)

ENT-CRS-STS12c

ED-CRS-STS12c

ENT-ROLL-STS12c

(P, G)

STS-48c Cross-Connect Type (cct)

ENT-CRS-STS48c

ED-CRS-STS48c

ENT-ROLL-STS48c

(P, G)

STS-192c Cross-Connect Type (cct)

ENT-CRS-STS192c

ED-CRS-STS192c

ENT-ROLL-STS192c

(P, G)

Location A (loca)*

ENT-CRS-rr

ED-CRS-rr

ENT-ROLL-rr

(P, G)

Source Node TID

None

Location Z (locz)*

Destination Node TID

None

VT Location A (vtloca)*

VT Source Node TID

None

VT-Accessed STS-1 (vtacc)

YES

None

Channel Application (chappl)

ENT-CRS-rr

ED-CRS-rr

ENT-ROLL-rr

(P, G)

UNSWITCHED

None

Configuration → Cross-Connections

Configuration → Ethernet Service

Circuit ID (circuitid)

up to 36 ASCII characters

None

Cross-Connection Application (xcappl)

0-255

0

Cross-Connection Number (xcnum)

Any 9-digit number

000000000

Source Access Identifier (src_aid)

ENT-CRS-OCH

(P, G)

Remote port, OC-192 port, OCH port, OTS port, OTU2

None

Configuration → OCH Cross-Connections

Destination Access Identifier (dest_aid)

* In Release 3.1 and later releases, if automatic squelch map generation is enabled, Location A and Location Z are not required.

Note: The TL1 command security access levels are Privileged (P), Administration (A), General (G), Maintenance (M), and Reports-only (R).

November 2011Copyright © 2011 Alcatel-Lucent. All rights reserved.