Procedure 5-92: Clear "Lockout Switch" condition
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a Lockout Switch condition.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the Lockout Switch condition in the resulting alarm list and note the corresponding AID. |
2 |
Select Fault → Protection Switch to access the appropriate 2F BLSR Protection Group and perform a Clear Switch Type in the required Direction. End of steps |