Procedure 5-93: Clear "lockout switching" condition
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a lockout switching condition.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the lockout switching condition in the resulting alarm list and note the corresponding AID. |
2 |
Select Fault → Protection Switch to access the appropriate 1+1_OPTM Protection Group and perform a Clear Switch Type. End of steps |