Procedure 5-112: Clear "Path Integrity Failure" alarm
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to identify and clear a Path Integrity Failure alarm.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the Path Integrity Failure alarm in the resulting alarm list and note the corresponding AID. |
2 |
From the System View, select View → Rings → Circuit. Result: The View Circuit window opens. |
3 |
In the View Circuit window, locate the PIF (path integrity failure) at some point in the circuit and record the TID of that node. Click Close on the View Circuit window. |
4 |
Log in to a remote NE with the missing or incorrect cross-connection. |
5 |
From the System View, select Configuration → Cross-Connections to access the Cross-Connection Wizard and provision a new (missing) cross-connection in the circuit or to modify the existing cross-connection. End of steps |