Procedure 14-34: View test measurements for internal test access session
Overview
Important!
The network element must be equipped with Very Large Fabric (VLF) circuit packs in the Main slots to support internal test access sessions.
Use this procedure to view test measurements for an existing internal test access session.
Privilege level
You must log in as either a Privileged, General, or Maintenance user to complete this procedure.
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to view test measurements for an existing internal test access session.
1 |
From the System View menu select Fault → Analysis → Test Access. Result: The Test Access Wizard appears. |
2 |
Click View test measurement in a test access session and Next. Result: A list of internal test access sessions appears that have either test signal detectors assigned or counting bins available. |
3 |
Select the required test access session and click View Measurement. Result: The Test Measurement Report appears for the test access session. If required, click Reset to restart monitoring and the initialize the counting bins to 0. |
4 |
Click Close to exit. End of steps |