Procedure 7-14: Set TARP parameters
Overview
This procedure allows you to provision user settable fields and functions relating to the following TARP capabilities for this NE:
Important!
Values should not be changed from default values except by users who intend to provision the SONET subnetwork and partition DCC communications. All the Layer 4 parameters that can be provisioned and are needed for NE operation have default values. Therefore, it is not necessary to provision these parameters for the NE to operate in the network.
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
Steps
Perform the following steps to provision TARP parameters, as required.
1 |
From the System View menu, select Administration → Data Communications. Result: The Data Communications window opens. |
2 |
TARP PARAMETERS Select the TARP tab. Result: The TARP parameters appear. |
3 |
Select Enable to enable TARP Data Cache or Disable to disable TARP Data Cache. |
4 |
Set the TARP Propagation Flush timer as required. |
5 |
Provision the TARP Lifetime and TARP Timers, as required. |
6 |
Click Apply, read the warning message, then click Yes to execute the command. |
7 |
TARP DATA CACHE Click on the TARP Data Cache tab. Result: The TARP Data Cache Entry List appears. |
8 |
Click on the sunglasses icon to add, modify, or delete entries. Follow the directions in the subsequent windows to edit the TARP Data Cache Entry NE Name and NSAP. |
9 |
Click Apply. |
10 |
TARP MANUAL ADJACENCIES Click on the TARP Manual Adj. tab. Result: The TARP Manual Adjacency parameters appear. |
11 |
Up to two Manual Adjacencies may be provisioned. Select one to provision by clicking on the Modify button next to MAJ1: or MAJ2:. Result: The NSAP Provisioning window opens. |
12 |
Modify the NSAP as required, then click OK. |
13 |
Click Apply at bottom of the window, read the warning message, then click Yes to execute the command or No to abort the command. |
14 |
Click Close to exit. End of steps |