The following table shows the provisionable channel parameters.
Parameter |
TL1 Commands (Access) (Note) |
Range |
Default |
Related WaveStar® CIT Commands |
---|---|---|---|---|
Primary State (pst) |
ENT-STS1 ENT-STS3c ENT-STS12c ENT-STS48c ENT-VT1 ENT-VC12 (P, G) |
OOS-MA-AS (AUTO), OOS (NMON) |
AUTO |
Configuration → Equipment |
ENT-OCH (P, G) |
OOS (NMON) OOS-MA-AS (AUTO) IS (In Service) |
AUTO | ||
TCA Monitoring Mode (tcamd) |
ENT-STS1 ENT-STS3c ENT-STS12c ENT-STS48c ENT-VT1 ENT-VC12 ENT-OCH (P, G) |
ENABLE, DISABLE |
ENABLE |
Performance → Prov PM Settings |
Signal Degrade Threshold (sfthr) |
ENT-STS1 ENT-STS3c ENT-STS12c ENT-STS48c (P, G) |
-5, -6, -7, -8, -9 |
-6 |
Configuration → Equipment |
ENT-VT1 (P, G) |
-5, -6, -7, -8 |
-6 | ||
Signal Fail Threshold (sfail) |
ENT-STS1 ENT-STS3c ENT-STS12c ENT-STS48c (P, G) |
-3, -4, -5 |
-3 |
Configuration → Equipment |
Alarm Severity Assignment Profile (pfname) |
ENT-ASAP-ASGNMT (P, G) |
DEFAULT ASAP User-Created ASAP |
DEFAULT ASAP | |
Default Tributary Maintenance (tribmntc_default) |
ENT-SYS (P) |
Allow, Inhibit |
Allow | |
Note: The TL1 command security access levels are Privileged (P), Administration (A), General (G), Maintenance (M), and Reports-only (R). |
November 2011 | Copyright © 2011 Alcatel-Lucent. All rights reserved. |