Delete test access session

Use this procedure to delete an existing test access session.

You must log in as either a Privileged, General, or Maintenance user to complete this procedure.

Prior to performing this procedure:

Refer to Before you begin and Required equipment in this chapter.
Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.
Obtain the work instructions for this procedure.
Verify that the work instructions identify the test access session to be deleted.

Complete the following steps to delete an existing test access session.


1	From the System View menu select Fault → Analysis → Test Access. Result: The Test Access Wizard appears.
2	Click Delete an existing test access session and Next.
3	Follow the directions in the remaining Test Access Wizard screens to delete the required test access session.
4	Verify the test access session parameters, then click Finish at the end of the Test Access Wizard screens. Result: A dialog box appears asking you to confirm executing this command. Click Yes and the Test Access Wizard appears. Click Close. End of steps