Procedure 5-91: Clear "Pluggable Transmission Module maintenance IP" condition
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a Pluggable Transmission Module maintenance IP condition.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the Pluggable Transmission Module maintenance IP condition in the resulting alarm list. |
2 |
Refer to the Probable Cause column in the alarm list and note the corresponding socket AID. |
3 |
Important! The Pluggable Transmission Module maintenance IP condition is reported when the socket Maintenance State parameter is provisioned to Maint. Select Configuration → Equipment to access the required socket and provision the Maintenance State parameter back to Normal. End of steps |