Procedure 5-99: Clear "ring upgrade mode" condition

- Overview

This procedure is used to clear a ring upgrade mode condition.

- Before you begin

Prior to performing this procedure:

  1. Refer to Before you begin and Required equipment in this chapter.

  2. Refer to Electrostatic discharge in Chapter 1, Safety.

Steps

Complete the following steps to clear the ring upgrade mode condition.

 
1

Using local procedures, determine if a network upgrade is being performed.

2

If a network upgrade...

Then...

is being performed,

This condition clears when the network upgrade is completed and the network element is manually provisioned back to the Normal mode.

STOP! End of Procedure.

is not being performed,

From the System View, select Configuration → Normal Mode.

Result: A dialog box appears asking you to confirm changing the NE Mode to Normal mode. Click Yes.

The ABN LED is turned off on the SYSCTL circuit pack faceplate and the Ring Upgrade mode is removed from the Alarm List.

End of steps

November 2011Copyright © 2011 Alcatel-Lucent. All rights reserved.