Procedure 5-15: Clear "dormant/exec code mismatch" condition
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a dormant/exec code mismatch condition.
1 |
From the System View, select Configuration → Software → Apply Software to schedule a Smart or Smart, Override Alarms software apply. Result: Approximately 15 minutes after the scheduled apply time, the apply is complete. You will be logged off the system when the system resets. A flashing b in the IND display on the SYSCTL indicates that a boot is in progress. During the boot, the b may extinguish for up to 20 seconds and then resume flashing. Reference: Procedure 6-20: Apply software generic |
2 |
Log back into the shelf. End of steps |