Procedure 5-34: Clear "Far-end protection line failure" alarm
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear an Far-end protection line failure alarm.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the Far-end protection line failure alarm in the resulting alarm list and note the corresponding AID. |
2 |
Contact personnel at the far-end site supplying the optical signal according to local procedures. The condition (trouble) is not in the local network element. Notify personnel at the far-end site to clear all alarms. End of steps |