Procedure 5-80: Clear "manual sync. mode switch" condition
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a manual sync. mode switch condition.
1 |
From the System View, select Fault → Timing/Sync Protection Switch → Clock Mode Switch, select Norm, and click OK. |
2 |
From the System View, click the Alarm List button and click Refresh. Result: The manual sync. mode switch condition is no longer present. End of steps |