Procedure 5-88: Clear "OCN facility loopback" condition
Overview
This procedure is used to clear an OCN facility loopback condition. The condition indicates that a user initiated an OC-n Facility Loopback.
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear an OCN facility loopback condition.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the OCN facility loopback condition in the resulting alarm list. |
2 |
Refer to the Probable Cause column in the alarm list, determine the affected port, and note the corresponding AID. |
3 |
From the System View, select Fault → Analysis → Loopback, expand the appropriate Optical circuit pack, select the affected port, and then click Select. Result: The Loopback window opens |
4 |
From the Loopback screen, select Facility and Release. Click Apply. Result: A warning message appears asking you to confirm executing this command. Click Yes and Close. End of steps |