Procedure 5-93: Clear "Port administratively disabled" condition
Overview
This procedure is used to clear a Port administratively disabled condition. The condition indicates that a user has disabled the Port Administration Control parameter.
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a Port administratively disabled condition.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the Port administratively disabled condition in the resulting alarm list. |
2 |
Refer to the Probable Cause column in the alarm list, and note the corresponding AID. |
3 |
From the System View, select Configuration → Equipment, expand the appropriate circuit pack, select the required port, and click Select. Result: The port provisionable parameters appear. |
4 |
Provision the Port Administration Control parameter as Enabled and click Apply. Result: A warning message appears asking you to confirm executing this command. Click Yes and Close. End of steps |