Clear "Pluggable Transmission Module insufficient maximum rate" alarm

Procedure 5-90: Clear "Pluggable Transmission Module insufficient maximum rate" alarm

Overview

This procedure is used to clear a Pluggable Transmission Module insufficient maximum rate alarm.

Before you begin

Prior to performing this procedure:

Refer to Before you begin and Required equipment in this chapter.
Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.

Steps

Complete the following steps to clear a Pluggable Transmission Module insufficient maximum rate alarm.

From the WaveStar^® CIT System View, click the Alarm List button and locate the Pluggable Transmission Module insufficient maximum rate alarm in the resulting alarm list.

Refer to the Probable Cause column in the alarm list and note the corresponding socket AID.

Important!

An XFP pluggable transmission module was inserted into a socket that cannot support the port rate.

From the System View, select View → Equipment to access the affected port and determine the required port rate.

Use office records to verify the correct pluggable transmission module/socket/port/circuit pack.

If...

Then...

correct pluggable transmission module was installed in the wrong socket/circuit pack,

Perform the following:

Remove the pluggable transmission module from the wrong socket/circuit pack and install the pluggable transmission module in the correct socket/circuit pack. (Refer to Procedure 6-5: Replace pluggable transmission module.)
Select Configuration → Update System → Update Inventory to update the system equipment list.

STOP! End of Procedure.

wrong pluggable transmission module was installed in the correct socket/circuit pack,

Perform the following:

Replace the wrong pluggable transmission module with the correct pluggable transmission module. (Refer to Procedure 6-5: Replace pluggable transmission module.)
Select Configuration → Update System → Update Inventory to update the system equipment list.

STOP! End of Procedure.

End of steps