Important!

When the network element is in the Maintenance Mode state, the IND display on the SYSCTL circuit pack faceplate shows MPx.x (where x.x is the generic number).

If the network element is in the Maintenance Mode state, the default User IDs/passwords must be used to log in to the network element. LUC01, LUC02, and LUC03 are the default privileged User IDs, and DMXTND2.5G is the default privileged password.

Log in to the network element.

Result:

The Maintenance Mode Wizard (Screen 1 of 4) appears.

Reference:

Procedure 6-2: Connect Personal Computer (PC) and establish WaveStar^® CIT session

Perform the following to choose/download and install the required valid generic and database.

1. Follow the Maintenance Mode Wizard (Screen 1 of 4) instructions to set the date and time and click Next.

2. Follow the Maintenance Mode Wizard (Screen 2 of 4) instructions to choose/download a generic and click Next.

3. Follow the Maintenance Mode Wizard (Screen 3 of 4) instructions to choose/download a database and click Next.

4. Follow the Maintenance Mode Wizard (Screen 4 of 4) instructions and verify that the correct generic and database were selected. Then click Finish.

Result:

The system resets and you are logged off the system.

A flashing b in the IND display on the SYSCTL indicates that a boot is in progress. During the boot, the b may extinguish for up to 20 seconds and then resume flashing.

Reference:

• Procedure 6-16: Ugrade software generic via SFTP

• Procedure 6-17: Upgrade software generic via FTP

• Procedure 6-18: Upgrade software generic via FTTD

• Procedure 6-19: Upgrade software generic via FTAM

Important!

If a default database was selected/installed, the default User IDs/passwords must be used to log in to the network element. LUC01, LUC02, and LUC03 are the default privileged User IDs, and DMXTND2.5G is the default privileged password.

If a valid (non-default) database was selected/installed, the provisioned User IDs/passwords may be used to log in to the network element.

When the system reset is complete, log back into the network element.

Reference:

Procedure 6-2: Connect Personal Computer (PC) and establish WaveStar^® CIT session

If a default database was selected/installed, restore the most recent network element database using the Configuration → Software → Remote Restore command, if required.

Reference:

• Procedure 6-21: Backup and restore NE database via FTP

• Procedure 6-22: Backup and restore NE database via FTTD

• Procedure 6-23: Backup and restore NE database via FTAM

End of steps