Procedure 5-109: Clear "Test access IP" conditions
Before you begin
Prior to performing this procedure, refer to Before you begin and Required equipment in this chapter.
Steps
Complete the following steps to clear a Test access IP condition.
1 |
From the WaveStar® CIT System View, click the Alarm List button, locate the Test access IP condition in the resulting alarm list, and note the corresponding AID . |
2 |
From the System View select Fault → Analysis → Test Access to access the Test Access Wizard. |
3 |
Click Delete an existing test access session and Next. |
4 |
Follow the directions in the remaining Test Access Wizard screens to delete the required test access session. |
5 |
Verify the test access session parameters, then click Finish at the end of the Test Access Wizard screens. Result: A dialog box appears asking you to confirm executing this command. Click Yes and the Test Access Wizard appears. Click Close. End of steps |