Procedure 14-20.3: Connect personal computer (PC) and establish remote CLI session using Ethernet network
Overview
Use this procedure to establish a remote CLI session with the VLNC40/VLNC60/VLNC61/VLNC64 circuit pack.
Important!
This procedure assumes that the proper connection interfaces have already been configured using the procedures in Procedure 14-21: Configure VLNC40/VLNC42/VLNC60/VLNC61/VLNC64 for in-band or out-of-band connectivity.
This procedure also assumes that Telnet or secure shell (SSH) access has been configured. See Telnet Commands and/or Secure Shell (SSH) commands in the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide.
Steps
1 |
Obtain a user name and password, if required, and the IP address of the VLNC40/VLNC42/VLNC60/VLNC61/VLNC64 from your network administrator. Important! You must obtain a user name and password if the default user name of admin has been changed. |
2 |
Establish a Telnet or secure shell (SSH) session from your PC using the default IP address or the IP address obtained from your network administrator. Result: The login User prompt displays when the terminal interface initializes. |
3 |
Enter user name and password. Important! The default User name is admin and the password is blank. Result: The User EXEC prompt [(ALU 1850TSS-5-xx) >] displays. The prompt may be changed using the set prompt <prompt_string> command in the user privilege mode. |
4 |
Refer to the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide, for help on using the CLI commands. End of steps |