Procedure 8-5: Provision performance monitoring (PM) settings
Privilege level
You must log in as a Privileged, General, or Maintenance user to provision performance monitoring and TCA reporting parameters.
TDM alarm, performance monitoring, and threshold crossing alert reporting
The following table shows the port/tributary provisionable parameters that affect TDM alarm, performance monitoring, and threshold crossing alert reporting.
|
TCA Monitoring Mode Parameter |
Port/Tributary Monitoring Mode Parameter | ||
|---|---|---|---|
|
IS |
AUTO |
NMON | |
|
Enable |
Yes Alarm Reporting Yes PM Reporting Yes TCA Reporting |
No Alarm Reporting No PM Reporting No TCA Reporting |
No Alarm Reporting No PM Reporting No TCA Reporting |
|
Disable |
Yes Alarm Reporting Yes PM Reporting No TCA Reporting |
No Alarm Reporting No PM Reporting No TCA Reporting |
No Alarm Reporting No PM Reporting No TCA Reporting |
Ethernet alarm, performance monitoring, and threshold crossing alert reporting
The following table shows the Ethernet port/VCG provisionable parameters that affect Ethernet alarm, performance monitoring, and threshold crossing alert reporting.
|
Ethernet Port/VCG PM Enable Parameter |
TCA Monitoring Mode Parameter = Enable (Note) | ||
|---|---|---|---|
|
Port/VCG Monitoring Mode Parameter | |||
|
IS |
AUTO |
NMON | |
|
Enable |
Yes Alarm Reporting Yes PM Reporting Yes TCA Reporting |
No Alarm Reporting No PM Reporting No TCA Reporting |
No Alarm Reporting No PM Reporting No TCA Reporting |
|
Disable |
Yes Alarm Reporting No PM Reporting No TCA Reporting |
No Alarm Reporting No PM Reporting No TCA Reporting |
No Alarm Reporting No PM Reporting No TCA Reporting |
|
Note: If the TCA monitoring mode parameter is disable, TCA reporting is disabled. | |||
Before you begin
Prior to performing this procedure, refer to Before you begin and Required equipment in this chapter.
Steps
Perform the following steps to provision performance monitoring and TCA reporting.
1 |
From the System View menu, select Performance → Prov PM Settings. Result: The Provision PM window opens. |
2 |
Expand the details for the required circuit pack with the ports, tributaries, or VCGs being provisioned. Click on the required port, tributary, or VCG you want to provision, then click Select. |
3 |
Provision parameters as required and click Apply. Result: A dialog box appears asking you to confirm executing this command. |
4 |
Read the warning message and click Yes to execute the command. Click Close to exit. End of steps |