Procedure 5-16: Clear "dormant/exec code mismatch" condition
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a dormant/exec code mismatch condition.
1 |
From the System View, select Configuration → Software → Apply Software to schedule a Smart (without Override) or Smart (with Override) software apply. Result: Approximately 15 minutes after the scheduled apply time, the apply is complete. You will be logged off the system when the system resets. Reference: Procedure 6-9: Apply software generic |
2 |
Log back into the shelf. End of steps |