Procedure 5-49: Clear "loopback (to Fiber)" condition
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a loopback (to Fiber) condition.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the loopback (to Fiber) condition in the resulting alarm list. |
2 |
Refer to the Probable Cause column in the alarm list, and note the corresponding port AID. |
3 |
From the System View menu, select Fault → Analysis → Port Loopback. Expand the appropriate groups, select the affected port, and click Select. Result: The loopback parameters appear. |
4 |
Select Release and Terminal. Click Apply. Result: A warning appears asking you to confirm executing this command. Click Yes and Close. End of steps |