Procedure 5-57: Clear "Pluggable Transmission Module removed" alarm

- Overview

This procedure is used to clear a Pluggable Transmission Module removed alarm.

- Before you begin

Prior to performing this procedure:

  1. Refer to Before you begin and Required equipment in this chapter.

  2. Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.

Steps

Complete the following steps to clear a Pluggable Transmission Module removed alarm.

 
1

From the WaveStar® CIT System View, click the Alarm List button and locate the Pluggable Transmission Module removed alarm in the resulting alarm list.

2

Determine the alarm level for the Pluggable Transmission Module removed alarm. Clear the alarms in order of severity.

3

Refer to the Probable Cause column in the alarm list, determine the pluggable transmission module removed, and note the corresponding socket AID.

4

Using office records, determine if the required socket should contain a pluggable transmission module.

5

Do office records show that the required socket should contain a pluggable transmission module?

If...

Then...

Yes,

Obtain the missing pluggable transmission module and install it into the required slot.

Refer to the pluggable transmission module installation procedure in the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) User Provisioning Guide.

No,

Perform the following:

  1. Select View → Cross-Connections to obtain a current list of cross-connections. If required, select Configuration → Cross-Connections to access the Cross-Connection Wizard and delete any cross-connections to the affected pluggable transmission module.

  2. Select Configuration → Update System → Update All.

    A dialog box appears asking you to confirm executing this command. Click Yes.

    This system update clears the Pluggable Transmission Module removed alarm.

End of steps

Copyright © 2011 Alcatel-Lucent. All rights reserved.