Procedure 18-2.3: Configure DNS server addresses

- Overview

If required, use this procedure to configure DNS server addresses. This command is optional if no DNS are required.

This command is used to provide DNS server addresses for the remote system connected to the MLG interface. The address is provided through IPCP message.

Refer to the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide, for help on using CLI commands.

Step
 
1

If required, login to the VLNC60/61/62.

Result:

The User EXEC prompt [(ALU switching)>] displays.

2

Enter the Global Config mode:

  1. From the User EXEC prompt, enter enable to enter the Privileged EXEC mode.

  2. From the Privileged EXEC prompt, enter configure to enter the Global Config mode.

3

From the Global Config mode, enter ip dhcp pool <name> to enter IP DHCP Pool Config mode, where name specifies the name of the DHCP pool.

4

From the IP DHCP Pool Config mode, enter dns-server <primary ip address> <secondary ip address>, where primary/secondary ip address is the IP address of the DNS servers being used.

The secondary IP address configuration is optional if only one IP address is to be exchanged using IPCP.

End of steps

Copyright © 2011 Alcatel-Lucent. All rights reserved.