Procedure 18-2.2: Configure VLANs for multilink group (MLG) interface
Overview
If required, use this procedure to configure the service VLANs to be pushed on traffic towards Ethernet links. If it is not specified, there will be no VLAN pushed on the traffic coming in from the multilink interface. This command is optional if no VLANs are to be assigned to the multilink group (MLG) interface.
The VLNC60/61/62 supports VLAN tagging based on each MLG when forwarding traffic from the MLPPP interface over the IEEE 802.1q Ethernet interface. This allows separation of traffic within the EATN. The VLNC60/61/62 supports 32 VLANs for ML-PPP.
Refer to the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide, for help on using CLI commands.
Step
1 |
If required, login to the VLNC60/61/62. Result: The User EXEC prompt [(ALU switching)>] displays. |
2 |
From the User EXEC prompt, enter enable to enter the Privileged EXEC mode. Result: The Privileged EXEC prompt [(ALU switching)#] displays. |
3 |
From the Privileged EXEC mode, enter vlan database to enter the VLAN Config mode. Example: (ALU Switching)# vlan database. |
4 |
From the VLAN Config mode, enter vlan <vlanid> where vlanid is a value in the range of 2-3965. Example: (ALU Switching) (VLAN)# vlan 10 Enter exit to return to the Privileged EXEC mode. End of steps |