Procedure 17-2.1: Configure VLNC64 OC3/STM1 interfaces

- Overview

Use this procedure to configure the VLNC64 OC3/STM1 interfaces used for circuit emulation service.

Refer to the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide, for help on using CLI commands.

Step
 
1

Login to the VLNC64.

Result:

The User EXEC prompt [(ALU switching)>] displays.

2

Enter the Global Config mode:

  1. From the User EXEC prompt, enter enable to enter the Privileged EXEC mode.

  2. From the Privileged EXEC prompt, enter configure to enter the Global Config mode.

3

From the Global Config mode, enter interface <interface-number>, to enter the Interface Config Mode where “interface-number” is a number in the range of main-{1-2}-{1} for the port you are provisioning.

Example: (ALU Switching)(Config)# interface main-2-1.

4

Specify a description for the interface.

From the Interface Config Mode, enter interface <description> where description is in a range of 1-32 alphanumeric character string.

Example: (ALU Switching) (Interface main-2-1 HubSiteSlot1Port1

5

Enter exit to return to the Global Config Mode.

End of steps

Copyright © 2011 Alcatel-Lucent. All rights reserved.