Procedure 7-7: Enable/disable SNMP traps
Before you begin
Obtain the work instructions for this procedure.
Step
1 |
Log in to the VLNC6x circuit pack being provisioned. |
2 |
From the Navigation menu, select PDH/TDM → Fault Management → TRAPS Admin. Result: The TRAPS Admin screen appears. |
3 |
Select the required Interface Type. Enable/disable the TRAPS State as required, then click Submit. |
4 |
From the Navigation menu, select PDH/TDM → Fault Management → TRAPS Configuration Summary and verify that the TRAPS State was provisioned correctly. Result: The TRAPS Configuration Summary screen appears. End of steps |