From the Navigation menu, select Routing → IP → Configuration to enable and configure IP Routing on the switch. Enter the required parameters, then click Submit.

For the equivalent CLI commands and descriptions, see IP Routing commands under Routing commands in the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide.

Parameters:

• Default Time to Live - The computed TTL (Time to Live) of forwarding a packet from the local router to final destination. This is a display only field.

• Routing Mode - This is the IP Routing Admin mode. Valid values are Enable or Disable.

• IP Forwarding Mode - This enables or disables the forwarding of IP frames.

• Maximum Next Hops - This is a display-only field.

• Distance - The default distance for static routes. Valid values: an integer in the range of 1-255 or null. The default value is 1. A null entry deletes the default distance for static routes. In this case, each static route has its own distance.

From the Navigation menu, select Routing → IP → Interface Configuration to enable and configure IP Routing on an individual interface. Enter the required parameters, then click Submit.

For the equivalent CLI commands and descriptions, see IP Routing commands under Routing commands in the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide.

Parameters:

• Slot/Port - Select the interface for which data is to be displayed or configured.

• IP Address - Enter the IP address for the interface.

• Subnet Mask - Enter the subnet mask for the interface. This is also referred to as the subnet/network mask, and defines the portion of the interface's IP address that is used to identify the attached network.

• Routing Mode - Setting this enables or disables routing for an interface. The default value is enable.

• Administrative Mode - The Administrative Mode of the interface. The default value is enable.

• Link Speed Data Rate - Physical link data rate of the interface. The unit is Mbps (Megabits per second). This is a display-only field.

• Active State - Indicates whether the interface is active or inactive. This is a display-only field.

• MAC Address - The burned in physical address of the specified interface. This is a display-only field.

• IP MTU - The size of the largest IP packet that can be transmitted on the interface without fragmentation. Valid values: an integer in the range of 68 - 1500. The default value is 1500.

From the Navigation menu, select Routing → IP → Interface Brief Summary to display summary information about IP configuration settings for all ports in the system.

End of steps