Procedure 13-2.2: Configure a service-multiplexed UNI on the VLNC40/42
Overview
Use this procedure to configure a service-multiplexed UNI port on the VLNC4x.
Service-multiplexing may only be enabled on UNI ports (ports where double VLAN tagging is not enabled.) Service multiplexing may not be enabled on a port unless there is at least one port on the circuit pack where double VLAN tagging is enabled.
Refer to the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide, for help on using CLI commands.
Step
1 |
From the User EXEC prompt, enter enable to enter the Privileged EXEC mode. |
2 |
Enter configure to enter the Global Config mode. |
3 |
From your work instructions, determine which ports are UNI ports. |
4 |
From the Global Config mode, enter interface <interface-number> to enter the Interface Config Mode, where “interface-number” is the address for the port (UNI) on which you will enable service-multiplexing. Example: (ALU Switching)(Config)# interface a-41. |
5 |
Enable the required customer UNI port to support service-multiplexing. From the Interface Config mode of the port you are provisioning, enter service-multiplexing. Example: (ALU Switching)(interface a-41) # service-multiplexing. End of steps |