Delete service-multiplexed mappings/service-multiplexed UNIs on VLNC40/42

Use this procedure to delete service-multiplexed mappings, or delete mappings and disable service-multiplexed UNIs on the VLNC4x.

Service multiplexed UNIs may not be disabled on a port if there are any mappings for that port.

Refer to the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide, for help on using CLI commands.

NOTICE

Service-disruption hazard

Deleting service-multiplexed mappings will cause service disruption. All packets using those VLANs will be filtered.


1	From the User EXEC prompt, enter `enable` to enter the Privileged EXEC mode.
2	Enter `configure` to enter the Global Config mode.
3	From the Global Config mode, enter `interface <interface-number>` to enter the Interface Config Mode, where “interface-number” is the address for the port (UNI) on which you will delete mappings. Example: (ALU Switching)(Config)# `interface a-42`.
4	From the Interface Config mode, enter `no map <cvlan> <svlan>` on the selected UNI port to delete the mappings for the specified vlans. Example: (ALU Switching)(interface a-42) # `no map 10 100`. Repeat this command for all mappings to be deleted.
5	Removing a mapping does not remove the cvlan or svlan from the interface’s vlan participation include list. If required, from the Interface Config mode, enter `vlan participation exclude <vlanid>` to remove the interface's participation in the selected vlans. Example: (ALU Switching)(interface a-42) # `vlan participation exclude 100`. Repeat this step as required.
6	If all service-multiplexed mappings have been deleted on this port and you want to disable service-multiplexing on this port, continue to the next step. Otherwise, Stop! You have completed this procedure. Service multiplexing may not be disabled on a port if there are any mappings for that port.
7	From the Interface Config mode, enter `no service-multiplexing` on the selected UNI port to disable service-multiplexing on this port. End of steps