vCPAA installation workflow for KVM
Stages
1 |
Copy the cpaa-vm.qcow2 image file to a directory on the host machine, for example: /var/lib/libvirt/images/. See the Virtual software configuration section for more information. |
2 |
Create the vCPAA. See To create a vCPAA on a KVM hypervisor for more information. |
3 |
Start the VM using the following command: virsh create /var/lib/libvirt/images/vcpaa.xml Note: The above command is an example only. The actual command must reflect the directory in which the XML file was saved, and the name of the XML file. |
4 |
Connect to the console port of the vCPAA using a Telnet session to the host. |
5 |
If prompted, enter BOF data (management port IP address, static routes). |
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.