To highlight PTP status

Steps
 

Choose Tools→Route Analysis→IGP Topology from the NFM-P main menu. The IGP topology map opens.


Perform one of the following:

  1. Right-click on the map and choose Highlight→Synchronization→Domain→All from the contextual menu. All IEEE 1588 PTP Synchronization-enabled NEs are highlighted.

  2. Right-click on the map and choose Highlight→Synchronization→Domain→Freerun/Initial from the contextual menu. All applicable IEEE 1588 PTP Synchronization-enabled NEs are highlighted.

  3. Right-click on the map and choose Highlight→Synchronization→Domain→Acquiring from the contextual menu. All applicable IEEE 1588 PTP Synchronization-enabled NEs are highlighted.

  4. Right-click on the map and choose Highlight→Synchronization→Domain→Phase Tracking from the contextual menu. All applicable IEEE 1588 PTP Synchronization-enabled NEs are highlighted.

  5. Right-click on the map and choose Highlight→Synchronization→Domain→Hold Over from the contextual menu. All applicable IEEE 1588 PTP Synchronization-enabled NEs are highlighted.

  6. Right-click on the map and choose Highlight→Synchronization→Domain→Locked from the contextual menu. All applicable IEEE 1588 PTP Synchronization-enabled NEs are highlighted.


To remove the path highlights, refer to To manage active highlights on a topology map .

End of steps

© 2023 Nokia. Nokia Confidential Information

Use subject to agreed restrictions on disclosure and use.