To create a BGP route profile
Steps
1 |
Choose Tools→Route Analysis→Route Profiles from the NFM-P main menu. The Route Profiles form appears. |
2 |
Perform one of the following:
The BGP Route Profile (Create) form opens. |
3 |
Configure the required parameters. |
4 |
Perform one of the following:
|
5 |
Perform one of the following:
|
6 |
Configure the Profile Type parameter. |
7 |
Perform one of the following:
|
8 |
Click on the Route Distinguishers tab and click Add. |
9 |
Configure the Value parameter and click OK. Note: A maximum of five BGP route profiles can share the same route distinguisher, but their route targets or communities must be unique. |
10 |
To add Route Targets, continue to Step 11 . Otherwise, go to Step 14 . |
11 |
Click on the Route Targets tab and click Add. |
12 |
Configure the Value parameter and click Apply. Note: A maximum of five BGP route profiles can share the same route target, but their communities must be unique. |
13 |
As required, repeat Step 12 to add additional Route Targets, up to a maximum of 20. Click OK when finished. |
14 |
Click on the Communities tab and click Add. |
15 |
Configure the Value parameter and click Apply. |
16 |
If creating an IP VPN BGP route profile, you may repeat Step 15 to add additional Communities, up to a maximum of 20. Click OK when finished. |
17 |
Save your changes and close the form. End of steps |
© 2023 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.