To create an LSP test policy
General information
The number of test results that are maintained by the CPAM is configured separately from the number of path records. The CPAM deletes historical results and historical path records at different intervals. Consider the following when you create an LSP path test policy and view associated path records or results:
Steps
1 |
Choose Tools→Service Test Manager (STM) from the NFM-P main menu. The Service Test Manager form opens. | ||||
2 |
Click on the Create button. | ||||
3 |
Choose Create Test Policy from the Create contextual menu. The Test Policy (Create) form opens. | ||||
4 |
Set the Entity Type parameter to LSP. | ||||
5 |
Configure the parameters: | ||||
6 |
Click on the Test Definitions tab button. | ||||
7 |
Click on the Add button to add a test definition to the test policy. A menu appears. | ||||
8 |
Choose one of the following from the contextual menu: The LSP test_type Definition (Create) form opens with the General tab displayed. | ||||
9 |
Configure the parameters: | ||||
10 |
Click on the Test Parameters tab button. | ||||
11 |
Perform one of the following:
| ||||
12 |
Click on the Results Configuration tab button. | ||||
13 |
Perform one of the following:
| ||||
14 |
Click on the Threshold Alarms tab button. | ||||
15 |
Click on the Create button. The Threshold Event Definition (Create) form opens. | ||||
16 |
Click on the Threshold Alarms tab button to configure threshold crossing alarms for test policies, test definitions, and assurance tests. An alarm is raised when a threshold is crossed, either because the value rose above or fell below the configured level. Configuring threshold crossing alarms on a test definition within the test policy creates a threshold definition that applies to generated tests. | ||||
17 |
Click on the Create button. The Threshold Event Definition (Create) form opens. | ||||
18 |
Perform the following:
| ||||
19 |
Perform Step 6 to Step 9 to add additional OAM tests to the policy. | ||||
20 |
Click on the OK button. The LSP test_type Definition (Create) form closes and a dialog box appears. | ||||
21 |
Click on the OK button. The dialog box closes and the test definition appears in the list of test definitions. | ||||
22 |
| ||||
23 |
Click on the OK button. The Test Policy (Create) form closes. | ||||
24 |
Close the Service Test Manager form. Note: To associate a test policy with an IP path monitor, LSP path monitor, or P2MP LSP path monitor, see Chapter 8, Path and prefix monitoring . End of steps |
© 2023 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.