To configure WRED QoS on a Wavence MSS
Note: You can enable WRED on UBT modules on an MSS-8, MSS-4, or UBT-SA device. Color mapping can be configured on MSS-8 and MSS-4 devices. When you configure radio queue settings, only select the UBT module which is online.
Steps
| |
|
1 |
Enable WRED on the Wavence MSS device by performing the following:
-
On the equipment tree, expand Network→Wavence.
-
Right-click on the Wavence MSS object and choose Properties.
-
Click on the QoS tab, enable the WRED Status parameter, and configure the Color Classification parameter. If required, configure Dot1p forwarding class mapping.
-
Save and close the form.
|
2 |
On the equipment tree, expand Network→Wavence→Shelf→Card Slot→Port.
|
3 |
Right-click on the UBT port and choose Properties. The Physical Port (Edit) form opens.
|
4 |
Click on the Radio Queue tab, then select a queue and click on the Properties button. The QoS Radio Interface Queue Map (Edit) form opens.
|
5 |
Configure the parameters as required, then save and close the forms.
End of steps |