How do I edit or delete baselines?

Steps
 
1 

Open Data Collection and Analysis Management, Baselines.

2 

Choose a baseline and click png1.png(Table row actions), Edit.

3 

To stop or restart monitoring, change the Admin State parameter.

If the admin state is Disabled, NSP stops monitoring the statistics.

4 

To stop or restart training, change the Training Status parameter.

If the training status is Paused, new data will no longer affect the calculated baseline.

5 

To reset training:

  1. If the Admin State is Enabled, select Disabled from the drop-down list and click UPDATE.

  2. Click RESET BASELINE WINDOWS and click APPLY to confirm.

  3. Wait a minimum of 15 min.

    You can close the form while you are waiting, if needed.

  4. Click RESET BASELINE WINDOWS again and click APPLY to confirm.

  5. Set the Admin State to Enabled and click UPDATE.

6 

To edit detectors:

  1. Click png3.png (Delete) to remove the existing detector.

  2. Click png2.pngRULE.

  3. In the Detector Rule form that opens, configure the new parameters.

  4. Click TEST to preview how your changes will impact the range of expected values.

  5. Click ADD.

7 

Click UPDATE.

8 

To delete baselines:

  1. Select one or more baselines and click png1.png(Table row actions), Delete.

    In the form that opens, confirm the deletion.

  2. From Data Collection and Analysis Management, Subscriptions, select a baseline subscription and click png1.png(Table row actions), Delete.

    Deleting the subscription also deletes all associated baselines.

End of steps