Perform one of the following:

1. From the Service Management, Services view, click (Table row actions), Audit config in-line with any service.

   Note: Users can select up to 10 services at a time to run the Audit Config action against.

2. From the Service Management, Services view, click on a service in the list, then expand the Alignment State section in the info panel and click AUDIT CONFIG.

The service is audited.

If an Audit Result form appears, one or more attributes and/or objects are misaligned. Review the results and click OK.

The Audit Result form closes.

To revert to the expected value of a misaligned attribute, or to restore a misaligned object, perform one of the following:

1. Click (Table row actions), Align, and then either Push to network or Pull from network in-line with the previously-audited service.

2. 1. Click on a service in the list, then expand the Alignment State section in the info panel and click ALIGN. The select alignment form opens.

   2. Select the Push to network or Pull from network radio button, then click CONTINUE. The select alignment form closes.

The service is synchronized with the network.

End of steps