To configure OSPF segment routing
Steps
1 |
In the navigation tree Routing view, expand Network→NE→Routing Instance→OSPF Instances. |
2 |
Right-click on an OSPF Instance object and choose Properties. The OSPF Site, Routing Instance, OSPF Instance (Edit) form opens. |
3 |
Click on the Behavior tab. |
4 |
In the General panel, set the Advertise Router Capability parameter to AS or to Area. Note: For OSPFv3, the parameter must be set to Area. |
5 |
Click on the Segment Routing tab. |
6 |
Set the Administrative State parameter to Up and configure the required parameters. The Prefix SID Start Label is configurable only when the Prefix SID Type parameter is set to Local. The minimum value you can enter for the Prefix SID Start Label parameter depends on the value of the Start Segment Routing Label parameter on the MPLS instance. See To configure an MPLS instance . |
7 |
To support dual adjacency SIDs, configure the parameters in the Adjacency SID panel. |
8 |
To configure OSPF/LDP segment routing interworking, perform the following: |
9 |
To configure an adjacency set and SID, perform the following:
|
10 |
Save your changes and close the form. End of steps |