To configure QoS policy overrides on port access egress queues for a 7210 SAS
Purpose
Perform this procedure to override the queue settings of a port access egress policy assigned to access ports on a 7210 SAS. When you enable overrides, you can change the settings for queues either to default settings or new values.
Steps
1 |
On the equipment tree, expand Network→NE→Shelf→Card Slot n→Daughter Card Slot n→Port n/n/n. |
2 |
Right-click on the Port icon and choose Properties. The Physical Port (Edit) form opens. |
3 |
Click on the Ethernet tab, then click on the Port Access Egress tab. |
4 |
Select a queue in the list, or click Create. The Port Access Egress Queue Override (Create|Edit) form opens. |
5 |
If you are creating an override queue, configure the ID and Displayed Name parameters. |
6 |
Click on the Override tab and configure the required parameters. To override a parameter, you must first select the associated Override check box. If the Default check box for a parameter is enabled, the value for that parameter is set at the default value determined by the NFM-P. If the MAX check box for a parameter is enabled, the value for that parameter is set at the MAX value. If required, deselect the associated Default or MAX check box to configure a non-default value. |
7 |
To override the queue management policy, click Select, choose a queue management policy from the list, and click OK. Note: The required queue management policy must be distributed to the NE that contains the port for which you are performing the policy override. Click Properties to view the properties form for the queue management policy. You can use this properties form to distribute the policy to the NE, if required. See Policy distribution . |
8 |
Save your changes and close the form. |
9 |
Configure additional queue overrides, or save your changes and close the form. End of steps |