To configure a 7250 SROS Ingress Classification policy

Before you begin

A 7250 SROS Ingress Classification policy associates ingress Dot1p, DSCP, and LSP-EXP CoS values with forwarding classes and profiles. A default FC and profile action is configurable for ingress traffic that does not have a CoS value.

The policy is assigned to the following QoS policies:

7250 SROS Ingress Classification policies are identified by the policy name; policy ID numbers are not used.

The NFM-P provides two default 7250 SROS Ingress Classification policies, one for SAP Access Ingress policies and the other for 7250 SROS Network Ingress policies. The default policies are not configurable, and cannot be deleted. A default policy is assigned to a SAP Access Ingress policy or 7250 SROS Network Ingress policy when no user-configured policy is explicitly assigned.

The 7250 IXR supports 7250 SROS Ingress Classification policies.

For more information about QoS policy support on the 7250 IXR, see 7250 IXR QoS policies.

Steps
 
1 

Choose Policies→QoS→SROS QoS→Ingress Classification→7250 SROS Ingress Classification from the NFM-P main menu. The 7250 SROS Ingress Classification form opens.

2 

Click Create, or choose an existing policy and click Properties. The 7250 SROS Ingress Classification Policy (Create|Edit) form opens.

3 

Configure the required parameters on the General tab.

If you are configuring a policy for a 7250 IXR NE that supports SROS FC mapping policies for ingress classification, assign the FC mapping policies in the Properties panel, then go to Step 7.

For more information about SROS FC mapping policies, see To configure FC mapping policies for ingress classification on the 7250 IXR.

4 

Click on the Dot1p tab to associate ingress Dot1p values.

  1. Click Create, or choose a Dot1p value from the list and click Properties. The Dot1p Forwarding Class form opens.

  2. Configure the parameters.

  3. Save your changes and close the form.

5 

Click on the DSCP tab to associate ingress DSCP values.

  1. Click Create, or choose a DSCP value from the list and click Properties. The DSCP Forwarding Class form opens.

  2. Configure the parameters.

  3. Save your changes and close the form.

6 

Click on the LSP-EXP tab to associate ingress LSP-EXP values.

  1. Click Create, or choose an LSP-EXP value from the list and click Properties. The LSP-EXP Forwarding Class form opens.

  2. Configure the parameters.

  3. Save your changes and close the form.

7 

Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policy to NEs.

End of steps