To configure a CPRI rate and channel management for a CDR channel on an 1830 VWM TLU or ITP card slot

Steps

 

On the equipment tree, expand Network→1830–VWM-OSU NE→1830–VWM-TLU shelf→Card Slot 1 TLU or Card Slot 1 ITP.


Right-click on the Card Slot 1 TLU or Card Slot 1 ITP object and choose Properties. The Card Slot (Edit) form opens.


Choose a CDR channel interface and click Properties. The CDR Channel (Edit) form opens.


Configure the CDR Channel Rate parameter.


Configure the CDR Channel Used For Mgmt parameter. The parameter is set to Disabled by default.

When the CDR Channel Used For Mgmt parameter is set to Enabled, the following configurations changes appear:

  • The CDR Channel Rate parameter is set to 1 GBE.

  • The port Administrative State parameter is set to UP.

  • The LOS Propagation Mode parameter is set to Laser off.

Editing of the following parameters is not supported:

  • Administrative State

  • AINS mode

  • Loopback, PRBS and monitoring settings

  • CDR Channel Rate

  • DWDM frequency


Save your changes and close the forms.

End of steps