To configure ANYsec encryption on an NE

Purpose

Perform this procedure to configure an sFlow receiver and counters on a supporting NE. Data for sFlow is collected on ports; for information about enabling sFlow on ports, see To configure a local connectivity association.

Steps
 

On the equipment tree, right-click on an NE and choose Properties. The Network Element (Edit) form opens.


Click on the ANYSec tab.


Configure the required general parameters.


Click on the Security Termination Policy tab and click Create. The Security Termination Policy (Create) form opens.

  1. Configure the required parameters.

  2. Save your changes and close the form.


Click on the Encryption Group tab and click Create. The Encryption Group (Create) form opens.

  1. Select a security termination policy in the Security Termination Policy Name panel.

  2. Select a MACsec connectivity association site in the Connectivity Association panel.

  3. Configure the other parameters, as required.

  4. Click on the Peer tab and click Create. The Peer (Create) form opens.

  5. Configure the required parameters.

  6. Save your changes and close the forms.


Save your changes and close the form.

End of steps