To configure an ILMI link
Steps
1 |
Perform Step 1 of To create an ILMI link to open the ATM Configuration (Edit) form. |
2 |
Click Edit ILMI Link. The ILMI Link form opens. |
3 |
Configure the required parameters. The Restore Keep-Alive Defaults parameter restores the default values of the Keep-Alive Polling Frequency (seconds), Keep-Alive Polling Count, and Keep-Alive Test Frequency (seconds) parameters. The Keep-Alive Test Frequency (seconds) parameter is configurable when the Protocol Version parameter is set to 4.0. |
4 |
Choose an ingress ATM QoS policy by clicking Select. The Select ATM Policy - ATM ILMI Link Configuration list form opens. Click Search and choose an ingress ATM policy from the list to associate with the ILMI link. Click OK. The Select ATM Policy - ATM ILMI Link Configuration list form closes. |
5 |
Choose an egress ATM QoS policy by clicking Select. The Select ATM Policy - ATM ILMI Link Configuration list form opens. Click Search and choose an egress ATM policy from the list to associate with the ILMI link. Click OK. The Select ATM Policy - ATM ILMI Link Configuration list form closes. |
6 |
Click on the Peer Interface Configuration tab to view ILMI properties of the peer interface of the link. |
7 |
Click OK to close the Configure ILMI Link form. The ATM Configuration (Edit) form opens. |
8 |
To remove an ILMI link, click Remove ILMI Link. Removing the ILMI link also removes the PVC. Note: An ILMI link can be removed only if its Administrative Status parameter is set to Disabled. |
9 |
Click Cancel to close the forms. End of steps |