To enable Stable Pool Sizing
Purpose
Perform this procedure to enable an even split of buffering amongst all possible MDAs.
When Stable Pool sizing is enabled, then for each MDA, the buffering is split between all ports based on the port maximum bandwidth and adjusted by the port’s modify buffer allocation rate percentages. You cannot enable Stable Pool Sizing on any forwarding plane on a card while the card is either administratively or operationally in Named Pool mode.
Steps
1 |
On the equipment tree, expand Network→NE→Shelf→Card Slot n. |
2 |
Right-click on the Card Slot object and choose Properties. The Card Slot form opens. |
3 |
Click on the Forwarding Plane tab, select a forwarding plane, and click Properties. The Forwarding Plane form opens. |
4 |
Configure the Stable Pool Sizing parameter and click OK. The form closes. |
5 |
Save your changes and close the forms. End of steps |