To configure a CPM

Purpose

Perform this procedure to configure CPM, CPM-s, CPM2, or CPM2-s objects.

Steps
 

On the equipment tree, right-click on the NE and choose Properties. The Network Element form opens.


On the Network Element tree, expand the Shelf object.


Right-click on Card Slot A or Card Slot B and choose Properties. The Card Slot form opens.

Alternatively, for the 7950 XRS, you can open a CPM Card Slot properties form by right-clicking on the associated CCM object and choosing View CPM from the contextual menu.

Note: Card Slot A and Card Slot B are automatically configured with CPMs. The CPMs cannot be removed, and they cannot be configured in any other card slot.


Configure the required parameters.


If the Flash Memory Module tab is available, you can perform the following steps. Depending on the device, only certain flash memory modules may be supported.

  1. Click on the Flash Memory Modules tab, select a flash memory module, and click Properties. The Flash Memory form opens.

  2. Configure the Administrative State parameter and click OK. The form closes.

    Note:

    You can configure flash memory modules on the 7950 XRS-20 from the CCM properties form. See To configure a CCM on a 7950 XRS-20 for more information.


If you are configuring a CPM on a 7950 XRS-20, the View CCM button is available. If required, click View CCM to open the properties form of the associated CCM.

See To configure a CCM on a 7950 XRS-20 for more information about the CCM properties form.


Save your changes and close the forms.

End of steps