To perform a search by specifying endpoints

Purpose

Perform this procedure to find objects such as service tunnels, MPLS paths, and LSP paths by specifying endpoints. You can search based on a source site endpoint, a destination site endpoint, or both. You can also search based on multiple source or destination endpoints at the same time.

Steps
 
1 

Choose Manage→MPLS→<object submenu> from the NFM-P main menu.

The Manage filter form for the selected object opens.

2 

If required, specify the object endpoint type in the Type column, otherwise go to Step 3 .

3 

Click the Filter icon. The filter configuration form opens.

4 

Choose Endpoints from the Select Filter Type menu.

Note: If a saved filter is selected, or a simple search filter is configured in the column headings, the Select Filter Type displays Advanced Filter by default.

To configure an advanced search, see To perform an advanced search from an object list form .

5 

If you know the source endpoint for the tunnel or path, deselect the Any Source parameter and choose the required source site. Otherwise, go to Step 6 .

You can choose multiple source sites in one filter.

6 

If you know the destination endpoint for the tunnel or path, deselect the Any Destination parameter and choose the required destination site.

You can choose multiple destination sites in one filter.

7 

Click Apply to perform the search. The filtered results are displayed.

8 

To save the configured filter, see To save search filters . Otherwise, close the filter configuration form.

9 

Select the required object in the list.

End of steps